The legs were later replaced and drain holes drilled at the bottom of all the legs to allow them to drain in the future to prevent this from happening. We just gave up and jury rigged this little saw horse and fence post system you see here. And believe me there was a lot of squeezing in a vice and pounding of hammers involved! The metal had warped out to the point it was impossible to squash back down small enough to pass through the bracket hole. The water froze over the winter, and because the legs were stowed in there shortest configuration it proved impossible to extend a couple of them. Water entered the tops of the leveling legs, which are hollow steel tubes with feet welded on the bottom. One interesting note is that we left the highbanker stored upright over the winter.

The little gulch almost goes dry later in the season. The creek is very small and so had to be ponded up for the system to work, and it used nearly all the water in the creek while operating. In this case we used a Keene 175-30 highbanker / dredge combo for the test work. It was mined out by hand as the stacked rocks reveal but some gold still remains. It is a small short drainage but was very rich at one time. This photo was taken on Skookum Gulch in the Wrangell Mountains of Alaska. Any claims not passing the exam would be lost. Short story is samples had to be taken at various locations to prove the claims have paying quantities of gold. I was involved in some validity exam testing on some mining claims in Alaska a few years ago.

Keene highbanker dredge